Ultimate Racing MBX8R carbon fiber wing mount stiffener & rear camber link plates

Shopping! Wartelle Shop

Shopping! Donuts Racing

Shopping! RC Team

Shopping! Aigoin Racing

The following press release is from Modelix Racing:

Ultimate Racing have introduced their new carbon fiber wing mount stiffener carbon fiber rear camber link plates intended for use with the Mugen Seiki MBX8R 1/8th nitro buggy. Take the durability of your MBX8R to the next level with this part, specifically designed for the most demanding drivers. The original wing mount often suffers from deformation due to impacts; this carbon fiber piece is the ultimate solution.

Maximum Rigidity and Strength

Manufactured from 3mm high-resistance carbon with a plain glossy finish, this plate structurally reinforces the wing mount. Thanks to its precision design, it press-fits into place and is secured using the original nuts and bolts, preventing the mount from bending or losing its original shape over time.

Aerodynamic Design

Unlike other solid reinforcements, its cross-shaped design has been thought to allow airflow through the wing mount. This ensures that the wing’s downforce remains unaffected, maintaining the car’s dynamic handling during jumps and high-speed cornering.

Key Features:

• Material: 3mm High-density Carbon Fiber (Plain Glossy).
• Compatibility: Mugen MBX8R and MBX8R ECO.
• Installation: Press-fit adjustment; uses original nuts and bolts—no complex modifications required.
• Durability: Prevents permanent deformation of the plastic mount.
• Lightweight: Provides maximum rigidity with minimal added weight.

Optimize your Mugen MBX8R geometry with the Ultimate Racing carbon rear camber link plates set. Designed to offer maximum precision in rear roll center adjustments, these parts replace the originals while providing significantly more configuration options in a single component.

3-in-1 Versatility: More Adjustments, Fewer Spares

Unlike Mugen’s optional parts (MSE2177 +3mm and MSE2178 0mm) which require purchasing and swapping the entire plate depending on the track, our plates integrate 3 different heights (0mm, 2.5mm, and 5mm) into the same carbon piece.

This allows you to vary the suspension turnbuckle position quickly and economically: simply change the mounting hole without the need to swap out the carbon plates.

Precision Geometry Tuning

Following the Mugen identification system, these parts feature a notched mark on the profile. Depending on whether you orient the mark toward the inside of the car or toward the wheel, you can vary both the height and the length of the link, allowing for total fine-tuning of the rear end’s handling.

Technical Features:

• Premium Material: Manufactured from 3mm high-resistance carbon with a plain glossy finish.
• Compatibility: Fully compatible with Mugen MBX8R and MBX8R ECO rear hubs.
• Efficiency: Save time and money; a single part covers all the adjustment ranges needed for any track condition.
• Pack Content: The bag includes the 4 units required to fully equip one car.